After discussion with the customer it was finally decided to keep the cover as tight as possible around the rear of the hull and motor as this had a separate cover.
This required fabricating a separate cover for the spare motor mounting bracket so that the cover could be used with the spare motor fitted if required. He advised us that he already had separate motor covers so did not need to cover these with this cover.
As there were many tight or wear points additional reinforcing was added to the cover.
Shock cord and hooks were used to tension the cover to the trailer this allowed for keeping the cover taught yet allowing ease of fitting.
We created a cut out and separate cover for the anchor roller at the bow in order to keep the cover as tight as possible along the waist line